|
|
濟寧力耐通液壓機械有限公司（www.lntyy.com）專業從事擺線液壓馬達，液壓制動器，液壓絞車的生產、代理、銷售，是集科、工、貿一體化的經營實體。公司坐落于孔孟之鄉，禮儀之邦，環境優美，交通便利的濟寧市工業開發區內。公司致力于發展高新設計和制造技術，進口多臺大型數控加工中心，數控成型磨床，數控內圓磨床等，制造和供應全規格的全液壓轉向器，擺線液壓馬達以及其它液壓產品。我們可以向用戶提供上千種各
液壓擺線馬達LMT系列
結構特點
LMT馬達是一種端面配流馬達。其結構特點：
•*的端面配流設計,低速轉動平穩。
•*的軸密封設計，能承受高背壓。
•*的配油機構設計, 具有磨損自動補償功能。
•雙列圓錐滾子軸承設計能夠承受較大的徑向力。
•多種法蘭、輸出軸、等安裝連接形式。
LMT motor is a disc valve type gerolor motor.
Characteristic features：
•Advanced design in disc distribution flow, which can provide improved performance at low speed.
•Advanced design of shaft seal, which can bear higher pressure.
•Advanced distribution mechanism design, which has the automatic compensation function.
•Double-rolling bearing design, which permit higher radial loads.
•A variety of connection types of flange; Rabbet:, output shaft and oil port.
1.zui大工作壓力指入口zui大壓力，連續工作壓力指工作壓差.
2.馬達不能同時在zui高壓力和zui大轉速下工作.
3.在斷續工作條件下，運行時間每分鐘不得超過10%.
4.*用68#抗磨液壓油，粘度37-73cSt，清潔度ISO18/13.
5.zui高工作油溫80°
6.馬達在滿負荷工作前，應在zui高工作壓力的40%以下磨合1小時.
7.馬達允許zui高背壓10MPa，但建議不要超過5MPa，超過時應接外泄油管.
1. Intermittent means the entrance of the maximum pressure; continuous working pressure means the differential pressure
2. Motor should not work under the highest pressure and the maximum speed
3. The running time should not exceed 10% under intermittent working conditions
4. Recommending N68 anti-wear hydraulic oil, viscosity 37-73cSt, cleanliness ISO18/13.
5. The Maximum working temperature is 80 °
6. One hour running time under 40% of maximum working pressure is recommended before full capacity working.
7. The maximum allowable back pressure is 10MPa, but the recommended back pressure should not exceed 5MPa.a leaking pipes isneeded when exceeding
*您想獲取產品的資料：
個人信息：
